Minicom Advanced Systems IP Control Guide de l'utilisateur télécharger pdf (Page 25)

USER GUIDE

Configuring Serial devices

25. Serial Device Interface

A Power Management device provides the means to turn on and off, Target Servers

connected to it. It has a number of individually (relay) controlled AC power

receptacles. It may also allow you to monitor current, voltage, power, temperature,

and other capabilities.

Smart IP Access can control most Power Management devices via its Serial Port.

Setup and control is performed at the Client computer, and is granted to

Administrators only.

Smart IP Access can control Power Management devices with a Serial interface.

26. Setting Up the RS232 port for Serial device

To set up the RS232 port:

1. From a Client computer, connect to Smart IP Access as an Administrator.

2. Select Settings/Serial Devices.

3. Set the Serial link parameters as defined for the Serial Device.

4. Connect a Serial cable to Smart IP Access Serial port and to the Serial device.

27. Initiating Serial device emulation

To initiate Serial device emulation:

1. Connect to Smart IP Access as an Administrator.

2. Select Reset/Serial Device. A "Serial emulation window" opens. You may

interact with a serial device, as if you were connected directly to the device

itself via its serial connection (refer to the Power Management unit

documentation for activities that may be performed with the specific Power

Management unit).

3. When finished close the Serial Device window.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 40 41

Pas de commentaire

Minicom Advanced Systems IP Control Guide de l'utilisateur Page 25