Minicom Advanced Systems Minicom Supervisor Phantom Guide d'installation télécharger pdf (Page 19)

INSTALLATION GUIDE

Note! IPMI V1.5 is only supported by server systems manufactured in 2002

onwards.

28. Connecting the Internal Reset/Power Option

Figure 19 shows the top view of the reset/power bracket.

To Reset pin

on Mainboard

To front panel

Reset switch

To Power On pin

on Mainboard

To front panel

Power switch

Figure 19 Reset/power bracket

Additional cables are required to enable the remote reset and power functions.

To install the bracket:

1. Mount the bracket in a free slot of the controlled system.

2. Find and disconnect the cable connecting the front panel reset button to the

main board.

3. Connect the cable to the pin connector on the bracket as shown in Figure 19.

4. Take the red/black reset cable and connect one end to the Motherboards reset

jumper connector and the other end to the bracket connector.

5. Find and disconnect the cable connecting the front panel power button and the

Motherboard.

6. Connect it to the pin connector on the bracket.

7. Take the red/black power cable and connect one end to the Motherboard 's

power jumper connector and the other end to the bracket connector.

8. Connect the bracket to the MX IP Serial port 2 using the supplied SUB-D 9 to

SUB-D 9 connector.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Pas de commentaire

Minicom Advanced Systems Minicom Supervisor Phantom Guide d'installation Page 19