Minicom Advanced Systems DX User IP Guide de l'utilisateur télécharger pdf (Page 18)

DX USER IP II

13. Administration > Serial Settings

Note! This section is only relevant to Standalone mode.

Where you have a Serial device connected to the DXU IP II you must configure the

RS232 settings.

To do so:

From the menu click Serial Settings, the Serial Settings appear, see Figure 12.

Figure 12 Serial Settings

Type a device name and choose the correct device parameters. Note! Where you

have a Minicom Serial Remote Power Switch connected, see below Assign to RPS.

13.1 Show

Tick Show to make the Serial device appear in the list of servers/devices that can be

accessed during a remote session.

13.2 Assign to RPS

Where a Minicom Serial Remote Power Switch (RPS) is connected to the Serial

port, tick this box. All other parameters are then grayed out. See the RPS Installation

Guide for further information on installing and operating the RPS.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Pas de commentaire

Minicom Advanced Systems DX User IP Guide de l'utilisateur Page 18