Minicom Advanced Systems RJ-45 Guide de l'utilisateur télécharger pdf (Page 70)

Upgrading the Supervisor Phantom firmware

8-11

10. In the

Phantom Update

program, check that the

firmware version number appears.

Contact our Technical Support department, if the OSD

will not display, or the firmware version number fails to

appear.

The Slave unit

When updating a

Slave

unit and a Communication Error

message appears, do the following:

1. Check that the Communication cable’s Stereo plug is

connected to the

Manager’s

Communication port.

2. Check that the Communication cable’s DB9F

connector is connected to the DB9M Serial port on

the CPU’s rear panel.

3. Check that the System cable, is connected.

4. Restart the download process from page 8-3, AND

make sure the Firmware Upgrade mode is activated.

Electricity failure or a rattling noise

When the electricity fails while updating the

Slave

firmware, or if you hear a rattling noise from the relay on

the

Slave

cards, do the following:

1. Switch off and disconnect the

Slave

computer from

the power supply.

2. Open the cover of the

Slave

computer extract the

Slave

card and close Jumper

JP9

. See Figure 8-8.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 83 84

Pas de commentaire

Minicom Advanced Systems RJ-45 Guide de l'utilisateur Page 70